iglide® J | Highly wear resistance on (almost) all shafts

• Over 250 dimensions available from stock
• Low wear against different shaft materials
• Low coefficients of friction in dry operation
• Vibration-damping
• Good resistance to chemicals
• Best material to use with soft shaft materials
• Very little humidity absoption

One main advantage of iglide® J plain bearings is the combination of a low coefficient of friction in dry operation and the low stick-slip tendency. With a recommended maximum surface pressure of 5076 psi, iglide® J plain bearings are not suitable for extreme loads.
 
Typical application areas
Vending machines
Printers
Beverage production & packaging
Aviation
Cleanroom

You will find plenty of additional application areas here: Browse all Industries
 

When to use it? For high speeds For highest wear resistance at low to medium pressures Low wear against different shafts Low coefficient of friction in dry operation Vibration dampening Good chemical resistance Best performance with soft shaft materials very little humidity absoption

When not to use? When high pressures occur If temperatures are higher than +194 °F When a cost-effective bearing for occasional movements is necessary Use our filter options to find the most suitable product

Tolerances and measurement system
The installation dimensions and tolerances of the iglide® plain bearings are a function of the material and wall thicknesses. For each material, the moisture absorption and the thermal expansion are imperative. Plain bearings with low moisture absorption can be designed with a minimal amount of tolerance. For wall thickness, the rule is: the thicker the bearings are, the larger the tolerances must be.
Testing methods
 
Assembly
iglide® bearings are press-fit bearings. The inner diameter adjusts only after press-fit in the proper housing bore with a recommended tolerance. The before press-fit oversized dimension can be up to 2% of the inner diameter. In this manner, the secure press-fitting of the bearing is achieved. Axial or radial shifts in the housing are also prevented.