Low coefficients of friction, optimized wear behavior
Space-saving, light,
High resistance to chemicals
Form-fitting clip-on in the housing bore
Axial securing is done by a snap ring groove (r)
Twist protection through engagement of the safety pin in hole ø z
Standard liner, inch
Liner, open design for supported shafts, inch
Clearance liner, inch
Clearance Liner, open design for supported shafts, inch
Liner for high temperatures, inch
Liner, closed design for the longest service life on steel/stainless steel round shafts, inch
Standard liner, mm
Liner, open design for supported shafts, mm
Liner with low clearance, mm (JUM-20 is dimensionally equivalent to JUM-11)
Low Clearance Liner, open design for supported shafts, mm
Extra short liner, mm
Low Clearance, Extra short liner, mm
Liner for high temperatures, mm
Liner for high temperatures, mm
Liner for high temperatures, mm
Liner, closed design for the longest service life on steel/stainless steel round shafts.
Liner, open design for the longest service life on supported steel/stainless steel round shafts
Installation by pressing into the H7 housing bore
Press fit bearing, Form S, mm
Press fit bearing, Form F, mm