Inquiry / Contact
igus® inc.

PO BOX 14349

East Providence

RI 02914

+1 800 521 2747
+1 401 438 7270

Core joining device for casting cylinder heads

Low cost and lighter

On this application, the aim is to change from the left-hand side of a cast mold to the right-hand side with as little effort as possible. For this purpose, the two compartments on the mold must be rotated 180 degrees with the utmost precision. The bearings used must be self-lubricating, as quartz sand is used here, which would get stuck to the lubricant. The iglide® PRT slewing ring bearing masters this job brilliantly, is lighter and in terms of purchasing is lower cost than a comparable metal rotary connector.

Klaus Augustin, Fill Gesellschaft m.b.H., Gurten

More on applied products here

Further interesting applications from extremely diverse areas can be found here.