iglide® J, thrust washer, mm

Highly resistant to wear on (nearly) all shafts with very low coefficients of friction

1 from 2

Part number: JTM-0512-020
Material: iglide® J
Form: Shop thrust washers
Dimensions:
- d1 5 mm
- d2 12 mm
- s 2 mm
Customize dimensions
Manufacturing method: Injection molding
Service life:

Material properties:

PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.

Highly resistant to wear on (nearly) all shafts with very low coefficients of friction
Low wear against different shaft materials
Low coefficients of friction in dry operation
Vibration-damping

iglide® J | Highly resistant to wear on (nearly) all shafts with very low coefficients of friction

Over 250 dimensions available from stock
Low wear against different shaft materials
Low coefficients of friction in dry operation
Vibration-damping
Good resistance to chemicals
Best material to use with soft shaft materials
Very little humidity absorption

One main advantage of iglide® J thrust washers is the combination of a low coefficient of friction when running dry and the low stick-slip tendency. With a recommended maximum surface pressure of 5076 psi, iglide® J thrust washers are not suitable for extreme loads.

Typical application areas
Vending machinery
Printing industry
Beverage industry
Aviation
Cleanroom

When to use it?