1 from 2
igus-icon-lupe
igus-three-dimensional-model
- Part number: JTM-0512-010
- Material: iglide® J
- Shape: Shop thrust washers
- Dimensions:
- d1 5.3 mm
- d2 12 mm
- s 1 mm
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.
- Highly resistant to wear on (nearly) all shafts with very low coefficients of friction
- Low wear against different shaft materials
- Low coefficients of friction in dry operation
- Vibration-damping
iglidur® J | The versatile endurance runner
iglidur® J is characterised by the lowest coefficients of friction in dry operation and its very low stick-slip tendency. With a maximum recommended surface pressure of 35MPa, iglidur® J is not suitable for extreme loads.
Typical applications
- Vending machinery
- Printing industry
- Beverage industry
- Aviation
- Cleanroom
When to use it?
- For high speeds
- When highest wear resistance at low to medium pressures is required
- Low wear against different shafts
- When a low coefficient of friction in dry operation is requested
- For vibration dampening
- When good chemical resistance is required
- For best performance with soft shaft materials
- Low moisture absorption
When not to use it?
- When high pressure loads occur
- When temperatures of greater than +120°C occur in the short term
- When a cost-effective bearing for occasional movements is sought
Unsure if it fits?
