1 from 2
igus-icon-lupe
igus-three-dimensional-model
- Part number: J3SM-0304-05
- Material: iglide® J3
- Shape: Sleeve bearings
- Dimensions:
- d1 3 mm
- d2 4.5 mm
- b1 5 mm
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.
- The new endurance runner: specialist for pulsating loads
- Low coefficients of friction
- Good liquid media resistance
- Very little humidity absorption
iglidur® J3 | The new endurance runner: Specialist for pivoting and pulsating loads
iglidur® J3 is a material with improved wear resistance at low to medium loads and high speeds. The service life is up to 300% higher than that of iglidur® J, the proven top endurance runner material.
Typical application areas
- Vending machinery
- Printing industry
- Beverage industry
- Glass industry
- Aviation
When do I use it?
- When the wear resistance of iglidur® J rotating or pivoting is to be further optimised
- When very low coefficient of friction is required in dry operation
- When high wear resistance at low load is sought
- When low moisture absorption is required
- When good media resistance is required
When do I not use it?
- If a wear-resistant material is required for linear strokes
- If temperatures permanently higher than +90°C occur
- If radial surface pressures greater than 45MPa occur
Unsure if it fits?
