1 from 2
igus-icon-lupe
igus-three-dimensional-model
- Part number: JSI-0203-03
- Material: iglide® J
- Shape: Shop sleeve bearings
- Dimensions:
- d1 0.125 inch
- d2 0.1875 inch
- b1 0.1875 inch
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for 96 PFAS substances considered critical for the environment and health. This category excludes substances from the group of fluoropolymers.
- The versatile endurance runner, highly resistant to wear on (nearly) all shafts with very low coefficients of friction
- Low wear against different shaft materials
- Low coefficients of friction in dry operation
- Vibration-dampening
iglidur® J | The versatile endurance runner
iglidur® J is characterised by the lowest coefficients of friction in dry operation and its very low stick-slip tendency. With a maximum recommended surface pressure of 35MPa, iglidur® J is not suitable for extreme loads.
Typical applications
- Vending machinery
- Printing industry
- Beverage industry
- Aviation
- Cleanroom
When to use it?
- For high speeds
- When highest wear resistance at low to medium pressures is required
- Low wear against different shafts
- When a low coefficient of friction in dry operation is requested
- For vibration dampening
- When good chemical resistance is required
- For best performance with soft shaft materials
- Low moisture absorption
When not to use it?
- When high pressure loads occur
- When temperatures of greater than +120°C occur in the short term
- When a cost-effective bearing for occasional movements is sought
Unsure if it fits?
