1 from 3
igus-icon-lupe
igus-three-dimensional-model
- Part number: JPRM-0608-00-010-060
- Material: iglide® J
- Shape: Shop wear rings
- Dimensions:
- d1 6 mm
- d2 8 mm
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.
- Easy to install
- Cost-effective
- More wear-resistant than PTFE-strips
- Higher load capacity
- Defined variables
iglidur® J | The versatile endurance runner
iglidur® J is characterised by the lowest coefficients of friction in dry operation and its very low stick-slip tendency. With a maximum recommended surface pressure of 35MPa, iglidur® J is not suitable for extreme loads.
Typical applications
- Vending machinery
- Printing industry
- Beverage industry
- Aviation
- Cleanroom
When to use it?
- For high speeds
- When highest wear resistance at low to medium pressures is required
- Low wear against different shafts
- When a low coefficient of friction in dry operation is requested
- For vibration dampening
- When good chemical resistance is required
- For best performance with soft shaft materials
- Low moisture absorption
When not to use it?
- When high pressure loads occur
- When temperatures of greater than +120°C occur in the short term
- When a cost-effective bearing for occasional movements is sought
Unsure if it fits?
