iglide® J, sleeve bearing with flange, imperial

The versatile endurance runner, highly resistant to wear on (nearly) all shafts with very low coefficients of friction

iglide® J, sleeve bearing with flange, imperial drawing

1 from 2

Part number: JFI-0203-03
Material: iglide® J
Shape: Flanged bearings
Dimensions:
- d1 0.125 in
- d2 0.1875 in
- d3 0.312 in
- b1 0.1875 in
- b2 0.032 in
Adjust dimensions
Manufacturing method: Injection molding
Service life:

Material properties:

PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.

The versatile endurance runner, highly resistant to wear on (nearly) all shafts with very low coefficients of friction
Low wear against different shaft materials
Low coefficients of friction in dry operation
Vibration-dampening

iglide® J | The versatile endurance runner
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.

Over 250 dimensions available from stock
Low wear against different shaft materials
Low coefficients of friction in dry operation
Vibration-dampening
Good resistance to chemicals
Best material to use with soft shaft materials
Very little humidity absorption

One main advantage of iglide® J plain bearings is the combination of a low coefficient of friction in dry operation and the low stick-slip tendency. With a recommended maximum surface pressure of 5076 psi, iglide® J plain bearings are not suitable for extreme loads.

When to use it?

For high speeds
For highest wear resistance at low to medium pressures
Low wear against different shafts
Low coefficient of friction in dry operation
Vibration dampening
Good chemical resistance
Best performance with soft shaft materials
Very little humidity absorption

When not to use?

When high pressures occur
When short-term temperatures occur that are higher +248 °F
When a cost-effective bearing for occasional movements is necessary

Unsure if it fits?

iglide® J, sleeve bearing with flange, imperial

The versatile endurance runner, highly resistant to wear on (nearly) all shafts with very low coefficients of friction

Contact Us

Questions or product information? Please contact:

Customer Service