1 from 2
igus-icon-lupe
igus-three-dimensional-model
- Part number: RFM-0405-03
- Material: iglide® R
- Shape: Shop flange bearings
- Dimensions:
- d1 4 mm
- d2 5.5 mm
- d3 9.5 mm
- b1 3 mm
- b2 0.75 mm
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.
- Low-cost material, low wear
- Good abrasion resistance
- Low coefficients of friction in dry operation
- Cost-effective
iglidur® R | Low-cost material, low coefficients of friction
In the development of iglidur® R, the focus was on high performance and a very low price. In particular, low friction and wear values were to be achieved in dry running. Components made of iglidur® R are specifically supported by a combination of solid lubricants. The PTFE and silicone-free material achieves outstandingly low friction values in dry running and runs largely stick-slip-free.
Typical areas of application
- Motorcycle/Rolloler
- Furniture/industrial design
- Sport, fitness & rehab
When do I use it?
- When high wear resistance at low loads is required
- When a very inexpensive material is required
- When very low coefficients of friction are required in dry running
- When edge loads occur
- When low moisture absorption is desired
- When PTFE or silicone are not approved for the application
When should I not use it?
- When high pressure loads occur
- When temperatures are permanently higher than +90 °C
- When the best possible wear resistance is required
Unsure if it fits?
