1 from 2
igus-icon-lupe
igus-three-dimensional-model
- Part number: RFM-0405-04
- Material: iglide® R
- Shape: Flange bearings
- Dimensions:
- d1 4 mm
- d2 5.5 mm
- d3 9.5 mm
- b1 4 mm
- b2 0.75 mm
- Customize dimensions
- Manufacturing method: Injection molding
- Service life:
PFAS-tested: All iglide materials labeled as "PFAS-tested" were tested for the 96 PFAS substances considered critical for the environment and health using the SQP M1227 test method (LC-MS/MS and GC-MS) and do not contain any substances >0.1% by mass. This category excludes substances from the group of fluoropolymers.
- Low-cost material, low wear
- Good abrasion resistance
- Low coefficients of friction in dry operation
- Cost-effective
iglidur® R | Low-cost material, low coefficient of friction
During the development of iglidur® R, the focus was on high performance and a very low price. In particular, low coefficients of friction and wear were to be achieved in dry operation. Components made of iglidur® R are specifically supported by a combination of solid lubricants. The PTFE-free and silicone-free material achieves outstandingly low coefficients of friction in dry operation and runs largely stick-slip-free.
Typical application areas
- Motorcycle / scooter
- Furniture / Industrial design
Sport, fitness & rehab
When do I use it?
- If high wear resistance at low load is required
- If you are looking for a very reasonably priced material
- If a very low coefficient of friction is required in dry operation
- If edge loads occur
- If low moisture absorption is desired
- If PTFE or silicone are not approved for the application
When not to use it?
- If high pressure loads occur
- If temperatures are continuously higher than +90°C
- If the best possible wear resistance is required
Unsure if it fits?
