guidelite guide troughs

Cost effective long travel distances up to 150m

As construction kit system for long travels, primarily for low-speed applications with low cycle frequencies. The lower run of the e-chains® is guided in two L-shaped guide rails made from fiberglass-reinforced plastics. The upper run of the e-chain® is partially guided by guide angle-brackets mounted in one-meter intervals. One method to achieve the correct width involves clipping separators (Version 01) between the retainers. This makes the installation very easy, since subsequent adjustments are no longer needed. For an extended width spectrum, there is also the option to mount the guide angle-brackets on a C-rail (Version 02).

guidlite | Version 01

Description	Part No.
Installation set with separator for a fixed width, consisting of	9GL.64.50.450.XX
2 x guide angle-bracket + 1 x separator	(XX = width index for separator)
Guide rail kit (left and right)	9GL.64.30.2000
in the shown length (standard: 2,000 mm)
In-feed module that guides down the upper run of the e-chain®, 2000 mm	9GL.64.80.Serie.450.XX
Only for Series 2700R and 3500R roller e-chains® with centre in-feed	(XX = width index for separator)
Append Part No. with the width index XXX shown in the table.	Example: 9GL.64.50.450.05

In-feed principles

End in-feed operating principle:Recommended for all e-chains® in combination with guidelite

Center in-feed operating principle:only for roller e-chains® Series 2700R and Series 3500R.
Please use in-feed module 9GL.64.80. Series 450.XX, which guides down the upper run of the e-chain®

guidlite | Version 02

Description	Part No.
Installation set with C-profiles, consisting	9GL.64.50.LLL
of 2 x guide angle + 1 x C-profile + M8 screw set	(LLL = lenghts C-Profil)
Guide rail set (right and left)	9GL.64.30.2000
in the shown length (standard: 2,000 mm)
In-feed module that guides down the upper run of the e-chain®, 2000 mm	9GL.64.80.Series. LLL
Only for Series 2700R and 3500R roller e-chains® with centre in-feed	(LLL = lengths C-Profil)
Append the part no. with the length of the C-profile LLL indicated on the right side of the table.	Example: 9GL.64.50.175

In-feed principles

End in-feed operating principle:Recommended for all e-chains® in combination with guidelite

Centre in-feed operating principle:only for roller e-chains® Series 2700R and Series 3500R.
Please use in-feed module 9GL.64.80. Series LLL, which guides down the upper run of the e-chain®

Contact a Cable Carriers Expert

Whether you're interested in end-to-end, fully assembled solutions or looking to build your own customizable project, let us assist you with a solution based on your specific application and requirements. Contact us via the form below or call us at (800) 521-2747 to discuss your project today!